Setting up the  EF-48 Edge Finisher


edge finisher  



The EF-48 is designed to be flush mounted on the top of a sturdy workbench or table.   In this example, a section of countertop material has been mounted to a pair of sawhorses purchased from the local home hardware center.                



                                 




layout







Before installing the motor, and with the worktables removed from the base plate, lay the base plate on the work bench and mark the mounting holes and the motor location.  








drill and cut motor hole  







Cut out a clearance pocket for the motor and drill the mounting holes for the base plate.









mount base and motor






 Mount the base plate to the workbench and then  install the motor from below.










add the drive wheel






 Install the drive wheel on the motor shaft











 The motor must be wired for Clockwise rotation of the drive wheel when viewed from above.



horizontal view





 Horizontal view for clarity.













Back to Page 1